SPECIFICATIONS
- Heavy-duty modular Griddle range top with polished 1" thick steel plate. Each burner has a manual infinite control valve or is thermostatically controlled (see options). Each burner has a standing pilot.
- Unit has stainless steel front, sides and bottom, welded angle frame, and 1-1/4" front manifold with 1" rear gas connection.
- Available in sizes from 12" wide up to 72" wide.
- Unit is modular and mounts on a standard oven, convection oven, cabinet base, refrigerated base, or 4" legs for counter models. One of these bases must be ordered to complete this unit. See separate spec sheets for bases.
STANDARD FEATURES
- 2-1/2" high stainless steel splash
- Stainless steel grease can and gutter
- Standing pilots, one per burner
- Infinite control valves (g)
- 1-1/4" front gas manifold
- 1" rear gas supply connection
- Zamak die cast knobs with set screws
- Stainless steel front, sides and bottom
- Welded steel frame
- Welded body construction
- Stainless steel front plate shelf 3 5/8"
- 9" low back flue riser
OPTIONS
- Stainless steel back
- 4" high stainless steel splash guard
- Common multi-unit plate shelf up to 108"
- Extended plate shelf 6"
- Extended plate shelf 8"
- Belly bar with 1" space
- Belly bar with space for 1/9 condiment pans
- Cap and cover manifold ends
- Flue risers: 1" island trim, 25" high half back or 39" high tall back
- Shelving: single, 25" or 39" high and double 39" high with either solid shelf, tubular or a combination
- Legs 4" high for counter model
- 1" pressure regulator (shipped separately)
- Thermostatic burner control (t)
UTILITY INFORMATION
| Model |
Description |
Gas (BTU/Hr) |
Approx. SHP WT. |
| V12G or T |
12" wide Griddle Plate |
16,500 |
130 lb |
| V18G or T |
18" wide Griddle Plate |
25,000 |
200 lb |
| V24G or T |
24" wide Griddle Plate |
50,000 |
260 lb |
| V30G or T |
30" wide Griddle Plate |
60,000 |
300 lb |
| V36G or T |
36" wide Griddle Plate |
75,000 |
350 lb |
| V48G or T |
48" wide Griddle Plate |
100,000 |
520 lb |
| V60G or T |
60" wide Griddle Plate |
121,000 |
600 lb |
| V72G or T |
72" wide Griddle Plate |
150,000 |
700 lb |
GAS
Each unit to have a 1 1/4" front manifold that couples to adjacent equipment or is capped on ends. A 1" male NPT rear gas connection may be used for a gas supply or capped if supply is from adjacent unit(s). Minimum gas supply is 6" W.C. for natural gas and 11" W.C. for propane. Operating Pressure is 5" W.C. for natural gas and 10" for propane at the manifold. All units require a regulated gas supply (pressure regulator must be ordered as an option).
ELECTRICAL
No electrical requirements for top modules. Only convection oven base or refrigerated base requires electricity.
EXHAUST
Installation under an exhaust hood is required.
Specify type of gas when ordering. Specify altitude when above 2000 ft.
Note: All Viking units are modular. Rangetops are separate units and have separate model numbers from bases. To complete a range there must be a base item added, such as an oven, cabinet base, refrigerated base or legs.
Example: A 6-burner range with oven would be a V36B6 plus a V36SO.
Note: When used as counter units, the Tall Back risers/shelves are not available. Tall backs are for units with an oven or cabinet base only. Viking Commercial products are not approved or recommended for residential use.
Note: In line with company policies, Viking Range Corporation reserves the right to change material and specifications without notice.
|
|
